Workability and Compressive Strength of Mortar with Manufactured Sand
J. Environ. Nanotechnol., Volume 7, No 4 (2018) pp. 51-53
Abstract
Sand obtained from the river stream is broadly utilized as fine aggregate in the making of ordinary mortar. Because of extraction in abundance, characteristic sand has turned into a scarce material, and it must be protected. Sand obtained from the crushing of stone has better particle shape, size and surface textures than natural river sand due to the controlled degradation of natural rocks and has a very high potential to replace natural sand in the preparation of cement mortar. The effect of manufactured sand in mortar, in terms of workability and compressive strength, has been investigated in this work. River sand was replaced with manufactured sand in mortar at different percentages, at an interval of 10 and investigations were carried out. Results have shown that the trials of replacement resulted in substantial strength gain.
Full Text
Reference
IS 4031(Part 5)–2000 Method of physical tests of hydraulic cement Part 5 Determination of initial and final setting times, Bureau of Indian Standards, New Delhi.
IS 4031(Part 6)–2005 Method of physical tests of hydraulic cement Part 6 Determination of compressive strength of hydraulic cement other than the masonry cement, Bureau of Indian Standards, New Delhi.
IS 1489 (Part 1) - 1991 Specification for Portland Pozzolana cement, Part 1: Flyash based, Bureau of Indian Standards, New Delhi.
IS 383–1970 Specification for coarse and fine aggregate from natural sources for concrete, Bureau of Indian Standards, New Delhi
IS 2250-1981 Code of Practice for Preparation and Use of Masonry Mortars, Bureau of Indian Standards, New Delhi
Rameshwar, S. Ingalkar and Shrikant M. Harle, Replacement of Natural Sand by Crushed Sand in the Concrete, Landscape Architecture and Regional Planning, 2(1), 13-22 (2017)
https://doi.org/10.11648/j.larp.20170201.12
Suman, Brajesh Kumar and Srivastava Vikas, Utilization of stone dust as fine aggregate replacement in concrete, Journal of Multidisciplinary Engineering Science and Technology, 2(4), 704-708 (2015)