Open Access

An Investigation into the Impact of Nano-Additives on the Performance and Emission Levels of a Diesel Engine Fuelled by Nahar Biodiesel

R. Rohith Renish, amalajustus@gmail.com
Vel Tech Rangarajan Dr. Sagunthala R&D Institute of Science and Technology, Chennai, TN, India
Amala Justus Selvam Vel Tech Rangarajan Dr. Sagunthala R&D Institute of Science and Technology, Chennai, TN, India


J. Environ. Nanotechnol., Volume 13, No 3 (2024) pp. 408-417

https://doi.org/10.13074/jent.2024.09.243823

PDF


Abstract

Research on alternative fuels has been intense due to rising energy needs, fossil fuel depletion, rising fuel consumption rates, and the generation of toxic pollutants. The production of biodiesel included the use of nahar oil by acid esterification, followed by a trans-esterification process. 20% volume of nahar biodiesel blend (NME20) was blended with diesel considering it to be the optimized blend ratio. Nanoparticles such as titanium dioxide (TiO2) and aluminium oxide (Al2O3) were used to improve the properties of fuel. The additives were included into the biodiesel mix at concentrations of 25, 50, 75, and 100 parts per million (ppm), respectively. This research aims to evaluate the efficacy and ecological footprint of a diesel engine that utilises a blend of nahar biodiesel with the incorporation of nano additives. An experimental setup was implemented on a diesel engine with a single cylinder to assess its performance and emissions at various engine loads.  The tests demonstrated that the use of a biodiesel mix NME20 containing 100 ppm nano Al2O3, (NME20Al100), resulted in a significant increase of 12.48% in thermal efficiency when compared to the other fuels tested. The addition of Al2O3 to the NME20 with 100ppm also resulted with the reduction of 22.85%, 23.07% and 27.59% of CO, HC and smoke emissions, respectively. Despite the fact that NOx levels tend to rise when nano additions are used, SME20Al100 stands out as the best nano additive compared to SME20Ti100 because of its exceptional engine performance.

Full Text

Reference


Al-Dawody, M. F. and Edam, M. S., Experimental and numerical investigation of adding castor methyl ester and alumina nanoparticles on performance and emissions of a diesel engine, Fuel, 307, 121784 (2022).

https://doi.org/10.1016/j.fuel.2021.121784

Dash, S. K., Das, P. K., Ranjit, P. S., Kumar, A., Papu, N. H. and Lingfa, P., Use of Nahar biodiesel-diesel blend in a agricultural diesel engine, IOP Conf. Ser. Mater. Sci. Eng., 1057(1), p. 012045 (2021). IOP Publishing.

https://doi.org/10.1088/1757-899x/1057/1/012045

Dash, S. K., Lingfa, P., Das, P. K., Saravanan, A., Dash, D. and Bharaprasad, B., Effect of injection pressure adjustment towards performance, emission and combustion analysis of optimal nahar methyl ester diesel blend powered agricultural diesel engine, Energy, 263, 125831 (2023).

https://doi.org/10.1016/j.energy.2022.125831

El-Seesy, A. I., Abdel-Rahman, A. K., Bady, M. and Ookawara, S. J. E. C., Performance, combustion, and emission characteristics of a diesel engine fueled by biodiesel-diesel mixtures with multi-walled carbon nanotubes additives, Energy Convers. Manag., 135, 373-393 (2017).

https://doi.org/10.1016/j.enconman.2016.12.090

El-Seesy, A. I., Attia, A. M. and El-Batsh, H. M., The effect of Aluminum oxide nanoparticles addition with Jojoba methyl ester-diesel fuel blend on a diesel engine performance, combustion and emission characteristics, Fuel, 224, 147-166 (2018).

https://doi.org/10.1016/j.fuel.2018.03.076

Fadhil, A. B., Al-Tikrity, E. T. and Albadree, M. A., Biodiesel production from mixed non-edible oils, castor seed oil and waste fish oil, Fuel, 210, 721-728 (2017).

https://doi.org/10.1016/j.fuel.2017.09.009

Gad, M. S. and Jayaraj, S., A comparative study on the effect of nano-additives on the performance and emissions of a diesel engine run on Jatropha biodiesel, Fuel, 267, 117168 (2020).

https://doi.org/10.1016/j.fuel.2020.117168

Gad, M. S., Aziz, M. M. A. and Kayed, H., Impact of different nano additives on performance, combustion, emissions and exergetic analysis of a diesel engine using waste cooking oil biodiesel, Propuls Power Res., 11(2), 209-223 (2022).

https://doi.org/10.1016/j.jppr.2022.04.004

Ge, S., Brindhadevi, K., Xia, C., Elesawy, B. H., Elfasakhany, A., Unpaprom, Y. and Van Doan, H., Egg shell catalyst and chicken waste biodiesel blends for improved performance, combustion and emission characteristics, Fuel, 306, 121633 (2021).

https://doi.org/10.1016/j.fuel.2021.121633

Hasan, M. M. and Rahman, M. M., Performance and emission characteristics of biodiesel–diesel blend and environmental and economic impacts of biodiesel production: A review, Renew. Sustain. Energy Rev., 74, 938-948 (2017).

https://doi.org/10.1016/j.rser.2017.03.045

Heydari-Maleney, K., Taghizadeh-Alisaraei, A., Ghobadian, B. and Abbaszadeh-Mayvan, A., Analyzing and evaluation of carbon nanotubes additives to diesohol-B2 fuels on performance and emission of diesel engines, Fuel, 196, 110-123 (2017).

https://doi.org/10.1016/j.fuel.2017.01.091

Jain, A., Bora, B. J., Kumar, R., Saleel, C. A., Sharma, P., Ramaraj, R. and Balakrishnan, D., Estimation of the potential of Nahar biodiesel run diesel engine at varying fuel injection pressures and engine loads through exergy approach, Alex. Eng. J., 84, 262-274 (2023).

https://doi.org/10.1016/j.aej.2023.11.014

Jain, A., Bora, B. J., Kumar, R., Sharma, P., Medhi, B. J., Rambabu, G. V. and Deepanraj, B., Energy, exergy and emission [3E] analysis of Mesua Ferrea seed oil biodiesel fueled diesel engine at variable injection timings, Fuel, 353, 129115 (2023).

https://doi.org/10.1016/j.fuel.2023.129115

Kumar, R. S., Sureshkumar, K. and Velraj, R., Optimization of biodiesel production from Manilkara zapota (L.) seed oil using Taguchi method, Fuel, 140, 90-96 (2015).

https://doi.org/10.1016/j.fuel.2014.09.103

Kumar, V. and Saluja, R. K., The effect of operating parameters on performance and emissions of DI diesel engine fuelled with Jatropha biodiesel, Fuel, 278, 118256 (2020).

https://doi.org/10.1016/j.fuel.2020.118256

Pourhoseini, S. H. and Ghodrat, M., Experimental investigation of the effect of Al2O3 nanoparticles as additives to B20 blended biodiesel fuel: Flame characteristics, thermal performance and pollutant emissions, Case Stud. Therm. Eng., 27, 101292 (2021).

https://doi.org/10.1016/j.csite.2021.101292

Ramesh, D. K., Kumar, J. D., Kumar, S. H., Namith, V., Jambagi, P. B. and Sharath, S., Study on effects of alumina nanoparticles as additive with poultry litter biodiesel on performance, combustion and emission characteristic of diesel engine, Mater. Today Proc., 5(1), 1114-1120 (2018).

https://doi.org/10.1016/j.matpr.2017.11.190

Sadaf, S., Iqbal, J., Ullah, I., Bhatti, H. N., Nouren, S., Nisar, J. and Iqbal, M., Biodiesel production from waste cooking oil: an efficient technique to convert waste into biodiesel, Sustain. Cities Soc., 41, 220-226 (2018).

https://doi.org/10.1016/j.scs.2018.05.037

Sáez-Bastante, J., Ortega-Román, C., Pinzi, S., Lara-Raya, F. R., Leiva-Candia, D. E. and Dorado, M. P., Ultrasound-assisted biodiesel production from Camelina sativa oil, Bioresour. Technol., 185, 116-124 (2015).

https://doi.org/10.1016/j.biortech.2015.02.090

Sakthivadivel, D., Kumar, P. G., Prabakaran, R., Vigneswaran, V. S., Nithyanandhan, K. and Kim, S. C., A neem oil-based biodiesel with DEE enriched ethanol and Al2O3 nano additive: An experimental investigation on the diesel engine performance, Case Stud. Therm. Eng., 34, 102021 (2022).

https://doi.org/10.1016/j.csite.2022.102021

Sharma, A. and Murugan, S., Potential for using a tyre pyrolysis oil-biodiesel blend in a diesel engine at different compression ratios, Energy Convers. Manag., 93, 289-297 (2015).

https://doi.org/10.1016/j.enconman.2015.01.023

Sharma, V., Hossain, A. K., Ahmed, A. and Rezk, A., Study on using graphene and graphite nanoparticles as fuel additives in waste cooking oil biodiesel, Fuel, 328, 125270 (2022).

https://doi.org/10.1016/j.fuel.2022.125270

Suresh, M., Jawahar, C. P., Renish, R. R. and Malmquist, A., Performance evaluation and emission characteristics of variable compression ratio diesel engine using Argemone Mexicana biodiesel, Energy sources, Part A: Recovery, utilization, and environmental effects, 43(12), 1511-1523 (2021).

https://doi.org/10.1080/15567036.2019.1648593

Vyas, A. P., Subrahmanyam, N. and Patel, P. A., Production of biodiesel through transesterification of Jatropha oil using KNO3/Al2O3 solid catalyst, Fuel, 88(4), 625-628 (2009).

https://doi.org/10.1016/j.fuel.2008.10.033

Contact Us

Powered by

Powered by OJS